Bosch Serie 6 Service Mode -

Press and hold the and 'Rinse' buttons (or the two buttons labeled 'Reset' on some models). While holding them, press the On/Off button. Release all buttons when P0 appears on the display. Viewing Errors

Turn off. Press and hold “Finish In” and “Start/Pause” simultaneously. While holding, turn the dial to “Off” then to any program. Release buttons. The display shows “d01”. bosch serie 6 service mode

| Code | Test | |------|------| | C01 | Oven light and cooling fan | | C02 | Top heating element (lower power) | | C03 | Bottom heating element | | C04 | Circulating fan with ring heater | | C10 | Temperature sensor (PT1000) resistance check | | C20 | Error log (last 10 faults) | | C99 | Factory reset (clears all user data and error memory) | Press and hold the and 'Rinse' buttons (or

| Error | Appliance | Meaning | |-------|-----------|---------| | E:15 | Dishwasher | Water protection system activated – possible leak or float switch stuck | | E:24 | Dishwasher | Drain blockage or faulty drain pump | | E:09 | Dishwasher | Heater relay fault or calcified heating element | | F:18 | Washing Machine | Heating relay stuck – replace control board or heater | | E:30 | Washing Machine | Drain pump filter clogged or pump failed | | F:63 | Washing Machine | Motor tachometer signal missing – hall sensor issue | | C67 | Oven | Cooling fan runs continuously – probe short | | C71 | Oven | Temperature sensor open circuit | Viewing Errors Turn off