Sheetcam Hot Crack Upd -
Dropping the feed rate to 60–80% for the last 5mm of the cut allows the arc to stabilize and the "trail" of the plasma flame to catch up to the torch head, ensuring a cleaner severance. 2. The "Overcut" Technique Under your Jet Operation settings: Overcut: Set this to 2mm–5mm.
SheetCam is considered a low-cost professional tool. A perpetual license typically costs around (or approximately €239 depending on the vendor). Sheetcam license or alternative - Problems and questions sheetcam hot crack
If your plasma cutter supports it (like high-end Hypertherm units), SheetCam can be configured to signal the machine to ramp down the amperage gradually at the end of the line. Dropping the feed rate to 60–80% for the
